![st microelectronics windows 10 st microelectronics windows 10](https://4.bp.blogspot.com/-K9Sqa1QKDGc/VhS9RFnrFWI/AAAAAAAAALw/1OeJr7VnThc/s1600/Dell%2BPrecision%2BM6600.png)
St microelectronics windows 10 how to#
We will see later how to edit the Python scripts available in the PYBFLASH filesystem.įirst we will try to communicate with the Python command interpreter directly on the NUCLEO-WB55 development kit. Open the PYBFLASH device with Windows Explorer. Let’s look at the files generated by the MicroPython system with the Windows explorer: You can now communicate with the MicroPython software via the USB link. If you see this message, the operation is done Press the Reset button (SW4) above the USB_USER socket on the development kit.ĭon’t pay attention to the message: drive problem Now you need to move the jumper from connector CN7, PIN 5-7 to SWDIO: When the window is closed, programming is complete Use the “flash_dfu-util” software by double-clicking on it.Ī command prompt windows opens (it may be too fast to see it), please wait for programming to finish: This step could potentially be performed by the student, in the event that the MicroPython firmware needs to be updated. We will use the ** dfu-util ** software for this. It is now mandatory to program the card with the MicroPython firmware. Programming the board’s MicroPython firmware (dfu-util) We are now using USB communication with the NUCLEO-WB55 board under Windows.Įxit to Zadig software. Then start the driver installation by clicking on “Replace Driver”. Select “libusbK (v3.0.7.0)” using the arrows: If it doesn’t appear in the drop-down list, change the USB cable (some cables don’t work). Select “USB DFU in FS mode” from the drop-down list. Go to “Options” then click on “List All Devices”. Installation of the free USB driver (Zadig)Īllow the application to make changes by clicking the “Yes” button.
St microelectronics windows 10 install#
The first step is to install the free USB drivers to communicate with the STM32WB55 board.
![st microelectronics windows 10 st microelectronics windows 10](https://assets.lcsc.com/images/lcsc/900x900/20190629_STMicroelectronics-STM32F429IGT6_C54328_front.jpg)
This file must be present on each workstation.Ĭonnect the NUCLEO-WB55 board to your computer with the USB cable. Board programmingĭownload the “TP Python” folder on the Windows Desktop, available on the drive: TP_Python.zip We will be able to update the firmware by USB. These modifications allow the STM32WB55 to be configured in bootloader mode. Here is how the kit should be configured: Connect a micro USB_USER cable to the port below SW4.Move the SWDIO jumper and place it on pins 5 and 7 of the ARDUINO CN7 connector.These steps are to be carried out by the teacher with administrator rights under Windows 10 and this for each NUCLEO WB55 board used in the practical work.